this is what I always get:
U-Boot SPL 2020.07 (May 24 2023 - 21:04:19 +0800)
DRAM: 32 MiB
Trying to boot from MMC1
U-Boot 2020.07 (May 24 2023 - 21:04:19 +0800) Allwinner Technology
CPU: Allwinner F Series (SUNIV)
Model: Allwinner F1C100s Generic Device
DRAM: 32 MiB
MMC: mmc@1c0f000: 0, mmc@1c10000: 1
Setting up a 480x272 lcd console (overscan 0x0)
and then it just freezes there
the built-in program that came on the 16mb spi flash works fine, has a littlevgl demo
edit: I was able to finally get this buildroot to work https://github.com/mclewell/licheepi-nano-lcd
now I'm trying to figure out how to use st7789v 320x240 LCD display
Can you point me to the source of your information ??
]]>My goal is to boot from an sd card. not the NOR flash. I've swapped sd cards and it is still stuck at trying to boot from mmc1. Is this a general problem with this board?
]]>参考: 荔枝派zero/小智极客S3/V3s使用sunxi-fel 借 u-boot 启动 Linux系统, 无需 spi flash / TF 卡
https://whycan.com/t_2388.html
I built and sdcard image for the Lichee Pi Nano using the buildroot image at https://github.com/florpor. However on booting with the flashed sdcard
U-Boot SPL 2018.01-05679-g013ca457fd-dirty (Aug 02 2019 - 09:57:28) DRAM: 32 MiB Trying to boot from MMC1
and it hangs indefinitely. I would be very grateful for any ideas
]]>