WhyCan Forum(哇酷开发者社区)

各位大佬，有D133EBS的img文件吗？我这边编译之后出现以下问题(AiBurn 日志)：
[debug] WinEvent: Some devnode changed
[info ] Set upg work mode: 1
[debug] Blocksize 1 , chunk 1048576 * 0 , rest 2048
[debug] Offset: 0 Size: 2048
[debug]  Dev "1:1-4-2" Send the rest data 2048
[error] Dev "1:1-4-2" Failed to send data 2048
[error]  Dev "1:1-4-2" Failed to send 2048
[warn ] Try to resend firmware component image.info , try count: 1
[warn ] Try to recovery the connection
[error] Connection recovery failed!

串口输出：
Pre-Boot Program ... (24-05-30 17:09 569b02e)
USB/UART
cs=0, phase=3
cs=1, phase=2
Psram_init done.
goto run SPL

tinySPL [Built on Sep 19 2024 13:31:10]
[W] usbh_get_connect_id()107 usb 0 port change wait failed.
[E] main()172 Not find udisk.
Startup reason: Power-On-Reset
Firmware Component:
    name:      image.info
    partition:
    attr:      required
    Media:     RAM(0)
qspi0 freq (input): 99000000Hz
qspi0 freq ( bus ): 49500000Hz
[E] sfud_probe()475 sfud_device_init failed: ret 4
Failed to probe spinor flash.
[E] image_info_proc()117 NOR prepare failed

刚入门，我们这边是自己画的板子，因此想试试是硬件问题还是软件问题。
希望有大佬能提供编译好的D133EBS镜像文件。提前感谢各位大佬！