WhyCan Forum(哇酷开发者社区)

  case UART_II_RECV_RDY:
  for(i=0; i!=trigB; i++)
    {
	UINT8 data = UART1_RecvByte();
	if(RxCnt < 64)
	  {
          RxBuff[RxCnt ++] = data;
	  }
     }
  break;

  case UART_II_RECV_RDY:
  while(R8_UART1_LSR & RB_LSR_DATA_RDY)
    {
	UINT8 data = UART1_RecvByte();
	if(RxCnt < 64)
	  {
          RxBuff[RxCnt ++] = data;
	  }
     }
  break;

// 串口配置程序，使用例程
void UART1_DefInit( void )
{	
    UART1_BaudRateCfg( 115200 );
    // R8_UART1_FCR = (2<<6) | RB_FCR_TX_FIFO_CLR | RB_FCR_RX_FIFO_CLR | RB_FCR_FIFO_EN;		// FIFO´ò¿ª£¬´¥·¢µã4×Ö½Ú
    R8_UART1_FCR = (0<<6) | RB_FCR_TX_FIFO_CLR | RB_FCR_RX_FIFO_CLR;		// FIFO´ò¿ª£¬´¥·¢µã4×Ö½Ú
    R8_UART1_LCR = RB_LCR_WORD_SZ;	
    R8_UART1_IER = RB_IER_TXD_EN;
    R8_UART1_DIV = 1;	
}