固件下载: tiny200_rtt_awtk_800x480_w25q128_ns2009.rar
Copy Flash offset 1M to RAM 0x8000000 size:2508352
Copy Flash Ok!
Check Image Crc32:3055548643
Image OK, Goto 0x80000000 ...
\ | /
- RT - Thread Operating System
/ | \ 4.0.2 build Jan 14 2020
2006 - 2019 Copyright by rt-thread team
[SFUD] Find a Winbond flash chip. Size is 16777216 bytes.
[SFUD] W25Q128 flash device is initialize success.
clk_divider_set_rate 0 198000000 0
clk_divider_set_rate 0 198000000 0
[I/I2C] I2C bus [i2c0] registered
periph_get_pll_clk:600000000
cpu_get_clk:408000000
ahb_get_clk:200000000
apb_get_clk:100000000
[D/FAL] (fal_flash_init:61) Flash device | W25Q128 | addr: 0x00000000 | len: 0x01000000 | blk_size: 0x00001000 |initialized finish.
[I/FAL] ==================== FAL partition table ====================
[I/FAL] | name | flash_dev | offset | length |
[I/FAL] -------------------------------------------------------------
[I/FAL] | Littlefs | W25Q128 | 0x00600000 | 0x00a00000 |
[I/FAL] =============================================================
[I/FAL] RT-Thread Flash Abstraction Layer (V0.4.0) initialize success.
[I/FAL] The FAL MTD NOR device (Littlefs) created successfully
msh />[E/MMC] [err]:0x00000100, RTO
[E/MMC] mmc cmd 5 err
[I/SDIO] SD card capacity 1931264 KB.
msh />ls
Directory /:
flash <DIR>
mmc <DIR>
usb <DIR>
info.txt 41
msh />
msh />ls /mmc
Directory /mmc:
INFO.TXT 41
bcm.bin 80896
ip.bin 252176
f1c200 <DIR>
msh />ls /flash
Directory /flash:
ts_lib.dat 105
msh />
msh />ps
thread pri status sp stack size max used left tick error
-------- --- ------- ---------- ---------- ------ ---------- ---
aw_lp 6 suspend 0x00000138 0x00000800 23% 0x00000014 000
awtk 7 suspend 0x00000100 0x00010000 14% 0x00000007 000
tshell 20 running 0x00000210 0x00002000 14% 0x00000002 000
mmcsd_de 22 suspend 0x0000009c 0x00000400 49% 0x00000005 000
tidle0 31 ready 0x00000050 0x00000100 34% 0x00000013 000
msh />free
total memory: 53512944
used memory : 3151892
maximum allocated memory: 3160312
msh />list_device
device type ref count
-------- -------------------- ----------
sd0 Block Device 1
Littlefs MTD Device 1
i2c0 I2C Bus 1
gpio Miscellaneous Device 0
lcd Graphic Device 0
W25Q128 Block Device 0
spi00 SPI Device 0
spi0 SPI Bus 0
uart2 Character Device 0
uart0 Character Device 2
msh />
msh />
上电后先进行屏幕校准,校准完成后自动运行awtk的图表demo, enjoy it !!!
最近编辑记录 haidao (2020-01-14 22:26:45)
离线
补个靓照
离线