WhyCan Forum(哇酷开发者社区)

重新捡起了项目，把github上面的源码搞下来，添加了自己的flash型号，然后编译出t113s4的，结果ddr似乎有问题？有没有大佬看看是S4ddr还没配好吗？
I] AWBoot r6204 starting...
D] DRAM BOOT DRIVE INFO: V0.24
D] DRAM CLK = 936 MHz
D] DRAM Type = 3 (2:DDR2,3:DDR3)
D] DRAMC read ODT off
D] ZQ value = 0x2e
D] DDR efuse: 0xa
D] chip id efuse: 0x7200
D] DX0 state: 1
D] DX1 state: 0
D] ERROR: auto scan dram rank & width failed
D] auto_scan_dram_config() FAILED
D] DMA: init
T] DMA: test 0x44000000 ====> 0x44800000, len 512KB
T] DMA: provide channel 0
E] DMA: test timeout!
D] SPI: init
T] SPI: parent_clk=600MHz, div=3, n=1, m=3
T] SPI: CDR2 - n = 0
T] SPI: clock div=0
D] SPI: set clock asked=100MHz actual=100MHz mclk=200MHz
T] DMA: provide channel 0
T] SPI: tsfr mode=0 tx=1 rx=0
T] SPI: ISR=0x1032
T] SPI: tsfr mode=0 tx=2 rx=1
T] SPI: ISR=0x1033
T] SPI: tsfr mode=0 tx=1 rx=4
T] SPI: ISR=0x1033
T] SPI: tsfr mode=0 tx=2 rx=1
T] SPI: ISR=0x1033
T] SPI: tsfr mode=0 tx=2 rx=1
T] SPI: ISR=0x1033
D] SPI-NAND: enable Gigadevice Quad mode
T] SPI: tsfr mode=0 tx=3 rx=0
T] SPI: ISR=0x1033
T] SPI: tsfr mode=0 tx=2 rx=1
T] SPI: ISR=0x1033
I] SPI-NAND: GD5F2GM7UEYI detected
T] SPI: tsfr mode=0 tx=4 rx=0
T] SPI: ISR=0x1033
T] SPI: tsfr mode=0 tx=2 rx=1
T] SPI: ISR=0x1033
T] SPI: tsfr mode=2 tx=4 rx=40
T] SPI: ISR=0x1033