WhyCan Forum(哇酷开发者社区)

eth0: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        inet 192.168.1.105  netmask 255.255.255.0  broadcast 192.168.1.255
        inet6 fe80::34c9:e3ff:fef1:b805  prefixlen 64  scopeid 0x20<link>
        ether 36:c9:e3:f1:b8:05  txqueuelen 1000  (Ethernet)
        RX packets 35  bytes 4506 (4.5 KB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 33  bytes 4826 (4.8 KB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
        device interrupt 53 

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1  (Local Loopback)
        RX packets 108  bytes 8582 (8.5 KB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 108  bytes 8582 (8.5 KB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

[    9.523637] sunxi-gmac gmac1 eth0: eth0: Type(6) PHY ID 0007c0f1 at 0 IRQ poll (gmac1-0:00)
[    9.536922] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   12.630207] sunxi-gmac gmac1 eth0: Link is Up - 100Mbps/Full - flow control rx/tx
[   12.630245] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   29.963738] sunxi-gmac gmac1 eth0: Link is Down

最近编辑记录 cris8259 (2021-05-01 16:43:15)