网络启动后掉线

cris8259 · 2021-05-01 16:15:59

eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
inet 192.168.1.105 netmask 255.255.255.0 broadcast 192.168.1.255
inet6 fe80::34c9:e3ff:fef1:b805 prefixlen 64 scopeid 0x20<link>
ether 36:c9:e3:f1:b8:05 txqueuelen 1000 (Ethernet)
RX packets 35 bytes 4506 (4.5 KB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 33 bytes 4826 (4.8 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 53

lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1 (Local Loopback)
RX packets 108 bytes 8582 (8.5 KB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 108 bytes 8582 (8.5 KB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

[ 9.523637] sunxi-gmac gmac1 eth0: eth0: Type(6) PHY ID 0007c0f1 at 0 IRQ poll (gmac1-0:00)
[ 9.536922] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 12.630207] sunxi-gmac gmac1 eth0: Link is Up - 100Mbps/Full - flow control rx/tx
[ 12.630245] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 29.963738] sunxi-gmac gmac1 eth0: Link is Down

最近编辑记录 cris8259 (2021-05-01 16:43:15)

微凉VeiLiang · 2021-05-03 16:34:53

没有遇到过，帮顶

WhyCan Forum(哇酷开发者社区)

楼主 #1 2021-05-01 16:15:59 分享评论

网络启动后掉线

#2 2021-05-03 16:34:53 分享评论

Re: 网络启动后掉线

页脚