WhyCan Forum(哇酷开发者社区)

U-Boot SPL 2022.01 (Mar 04 2022 - 19:40:53 +0800)
DRAM: 64 MiB
Trying to boot from sunxi SPI


U-Boot 2022.01 (Mar 04 2022 - 19:40:53 +0800) Allwinner Technology

CPU:   Allwinner V3s (SUN8I 1681)
Model: zgtech v3s
DRAM:  64 MiB
WDT:   Not starting watchdog@1c20ca0
MMC:
Loading Environment from nowhere... OK
In:    serial@1c28000
Out:   serial@1c28000
Err:   serial@1c28000
Hit any key to stop autoboot:  0
Booting from SPI-NOR...
SF: Detected mx25l25635e with page size 256 Bytes, erase size 64 KiB, total 32 MiB
device 0 offset 0x100000, size 0x400000
SF: 4194304 bytes @ 0x100000 Read: OK
## Loading kernel from FIT Image at 41000000 ...
   Using 'conf@0' configuration
   Trying 'kernel@0' kernel subimage
     Description:  Linux kernel
     Type:         Kernel Image
     Compression:  uncompressed
     Data Start:   0x410000cc
     Data Size:    2581688 Bytes = 2.5 MiB
     Architecture: ARM
     OS:           Linux
     Load Address: 0x40000000
     Entry Point:  0x40000000
     Hash algo:    crc32
     Hash value:   288559c3
   Verifying Hash Integrity ... crc32+ OK
## Loading fdt from FIT Image at 41000000 ...
   Using 'conf@0' configuration
   Trying 'fdt@0' fdt subimage
     Description:  Flattened Device Tree blob
     Type:         Flat Device Tree
     Compression:  uncompressed
     Data Start:   0x41276668
     Data Size:    12422 Bytes = 12.1 KiB
     Architecture: ARM
     Hash algo:    crc32
     Hash value:   ede9cbe1
   Verifying Hash Integrity ... crc32+ OK
   Booting using the fdt blob at 0x41276668
   Loading Kernel Image
   Loading Device Tree to 43d6e000, end 43d74085 ... OK

Starting kernel ...

Booting Linux on physical CPU 0x0
Linux version 5.4.154 (root@3947f5fc0bff) (gcc version 9.4.0 (Buildroot 2021.02.8)) #1 Sat Mar 5 00:03:17 CST 2022
CPU: ARMv7 Processor [410fc075] revision 5 (ARMv7), cr=10c53c7d
CPU: div instructions available: patching division code
CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
OF: fdt: Machine model: zgtech v3s-dev
Memory policy: Data cache writeback
CPU: All CPU(s) started in HYP mode.
CPU: Virtualization extensions available.
Built 1 zonelists, mobility grouping on.  Total pages: 16256
Kernel command line: console=ttyS0,115200 earlyprintk rootwait init=/etc/preinit root=/dev/mtdblock2 rootfstype=squashfs overlayfsdev=/dev/mtdblock3
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes, linear)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes, linear)
mem auto-init: stack:off, heap alloc:off, heap free:off
Memory: 54984K/65536K available (6144K kernel code, 468K rwdata, 1356K rodata, 1024K init, 170K bss, 10552K reserved, 0K cma-reserved, 0K highmem)
SLUB: HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS: 16, nr_irqs: 16, preallocated irqs: 16
GIC: Using split EOI/Deactivate mode
random: get_random_bytes called from start_kernel+0x308/0x4b4 with crng_init=0
clocksource: timer: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 79635851949 ns
Console: colour dummy device 80x30
sched_clock: 32 bits at 100 Hz, resolution 10000000ns, wraps every 21474836475000000ns
Calibrating delay loop... 2013.59 BogoMIPS (lpj=10067968)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
CPU: Testing write buffer coherency: ok
Setting up static identity map for 0x40100000 - 0x40100060
devtmpfs: initialized
VFP support v0.3: implementor 41 architecture 2 part 30 variant 7 rev 5
clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
futex hash table entries: 256 (order: -1, 3072 bytes, linear)
pinctrl core: initialized pinctrl subsystem
NET: Registered protocol family 16
DMA: preallocated 256 KiB pool for atomic coherent allocations
cpuidle: using governor menu
hw-breakpoint: found 5 (+1 reserved) breakpoint and 4 watchpoint registers.
hw-breakpoint: maximum watchpoint size is 8 bytes.
pps_core: LinuxPPS API ver. 1 registered
pps_core: Software ver. 5.3.6 - Copyright 2005-2007 Rodolfo Giometti <giometti@linux.it>
PTP clock support registered
clocksource: Switched to clocksource timer
NET: Registered protocol family 2
IP idents hash table entries: 2048 (order: 2, 16384 bytes, linear)
tcp_listen_portaddr_hash hash table entries: 512 (order: 0, 4096 bytes, linear)
TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear)
TCP: Hash tables configured (established 1024 bind 1024)
UDP hash table entries: 256 (order: 0, 4096 bytes, linear)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear)
NET: Registered protocol family 1
workingset: timestamp_bits=30 max_order=14 bucket_order=0
squashfs: version 4.0 (2009/01/31) Phillip Lougher
jffs2: version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
Block layer SCSI generic (bsg) driver version 0.4 loaded (major 249)
io scheduler mq-deadline registered
io scheduler kyber registered
sun8i-v3s-pinctrl 1c20800.pinctrl: initialized sunXi PIO driver
Serial: 8250/16550 driver, 8 ports, IRQ sharing disabled
sun8i-v3s-pinctrl 1c20800.pinctrl: 1c20800.pinctrl supply vcc-pb not found, using dummy regulator
printk: console [ttyS0] disabled
1c28000.serial: ttyS0 at MMIO 0x1c28000 (irq = 29, base_baud = 1500000) is a U6_16550A
printk: console [ttyS0] enabled
loop: module loaded
sun8i-v3s-pinctrl 1c20800.pinctrl: 1c20800.pinctrl supply vcc-pc not found, using dummy regulator
spi-nor spi0.0: mx25l25635e (32768 Kbytes)
9 fixed-partitions partitions found on MTD device spi0.0
Creating 9 MTD partitions on "spi0.0":
0x000000000000-0x000000080000 : "u-boot"
0x000000100000-0x000000500000 : "kernel"
0x000000500000-0x000001000000 : "rom"
0x000001000000-0x000002000000 : "overlay"
0x000000000000-0x000000080000 : "dummy-u-boot"
0x000000080000-0x000000100000 : "dummy-splash"
0x000000100000-0x000000500000 : "dummy-kernel"
0x000000500000-0x000001000000 : "dummy-rom"
0x000000000000-0x000002000000 : "dummy-image"
sun6i-spi 1c68000.spi: chipselect 0 already in use
spi_master spi0: spi_device register error /soc/spi@1c68000/spi-nand@0
spi_master spi0: Failed to create SPI device for /soc/spi@1c68000/spi-nand@0
libphy: Fixed MDIO Bus: probed
dwmac-sun8i 1c30000.ethernet: IRQ eth_wake_irq not found
dwmac-sun8i 1c30000.ethernet: IRQ eth_lpi not found
dwmac-sun8i 1c30000.ethernet: PTP uses main clock
dwmac-sun8i 1c30000.ethernet: No regulator found
dwmac-sun8i 1c30000.ethernet: No HW DMA feature register supported
dwmac-sun8i 1c30000.ethernet: RX Checksum Offload Engine supported
dwmac-sun8i 1c30000.ethernet: COE Type 2
dwmac-sun8i 1c30000.ethernet: TX Checksum insertion supported
dwmac-sun8i 1c30000.ethernet: Normal descriptors
dwmac-sun8i 1c30000.ethernet: Chain mode enabled
dwmac-sun8i 1c30000.ethernet: device MAC address e2:a2:f6:fe:fd:6d
libphy: stmmac: probed
dwmac-sun8i 1c30000.ethernet: Found internal PHY node
libphy: mdio_mux: probed
dwmac-sun8i 1c30000.ethernet: Switch mux to internal PHY
dwmac-sun8i 1c30000.ethernet: Powering internal PHY
sunxi-wdt 1c20ca0.watchdog: Watchdog enabled (timeout=16 sec, nowayout=0)
sun8i-v3s-pinctrl 1c20800.pinctrl: 1c20800.pinctrl supply vcc-pf not found, using dummy regulator
sunxi-mmc 1c0f000.mmc: initialized, max. request size: 16384 KB
ipip: IPv4 and MPLS over IPv4 tunneling driver
IPv4 over IPsec tunneling driver
NET: Registered protocol family 10
Segment Routing with IPv6
sit: IPv6, IPv4 and MPLS over IPv4 tunneling driver
NET: Registered protocol family 17
hctosys: unable to open rtc device (rtc0)
random: fast init done
VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
devtmpfs: mounted
Freeing unused kernel memory: 1024K
Run /etc/preinit as init process
random: crng init done
Mounting OverlayFS: overlayfs: upper fs does not support tmpfile.
overlayfs: upper fs does not support xattr, falling back to index=off and metacopy=off.
OK
Starting zg-procd: OK
/etc/init.d/S01procd: line 5: zg_procd: not found
Starting syslogd: OK
Starting klogd: OK
Running sysctl: OK
Starting watchdog: /etc/init.d/S02watchdog: line 7: zg_read_config: not found
FAIL
no enable_watchdog
Populating /dev using udev: udevd[91]: starting version 3.2.9
udevd[92]: starting eudev-3.2.9
done
Saving random seed: OK
Starting network: OK
Starting timesync: /usr/bin/feed_dog: line 5: zg_read_config: not found
/usr/bin/feed_dog: line 6: zg_read_config: not found
/usr/bin/feed_dog: line 7: zg_read_config: not found
ntpd: bad address 'ntp.aliyun.com'
ntpd: bad address 'time1.cloud.tencent.com'
ntpd: bad address 'ntp.ntsc.ac.cn'
ntpd: bad address 'ntp.zgtech.ltd'
ntpd: bad address 'ntp.zgtech.ltd'
ntpd: bad address 'ntp.ntsc.ac.cn'
ntpd: bad address 'time1.cloud.tencent.com'
ntpd: bad address 'ntp.aliyun.com'
Alarm clock
OK
/usr/bin/feed_dog: line 5: zg_read_config: not found
/usr/bin/feed_dog: line 6: zg_read_config: not found
/usr/bin/feed_dog: line 7: zg_read_config: not found
Starting cron: OK

Welcome to zgtech
zgtech login: